Table of Contents
Advertisement
Installing the Shelf Controller Cards and Fabric Cards
Note
If the card does not slide easily into the slot during installation, the orientation may be wrong or the slot is not
for an SC or SC-SW card. Reorient the card, if necessary.
Figure 45: Installing an SC-SW or SC Card — SC-SW Card Shown
1
Direction of insertion
2
OIR button
Step 4
Place one hand under the card to support and guide it into the correct slot. Slide the card halfway into the slot. Avoid
touching the card circuitry or any connectors.
Alignment grooves exist on each slot in the card cage. When you install a card in the card cage, make sure that
Note
you align both edges of the card carrier in the slot grooves.
Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Guide
3
Ejector lever
4
Captive screw
Steps
73
Advertisement
Table of Contents
