Steps; Installing Ac Input Power Cords; Prerequisites - Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Manual

Table of Contents

Installing the Power Components

Steps

To install a PM slot cover in an AC or DC power tray, follow these steps:

Step 1

Attach the ESD-preventive wrist strap to your wrist and connect its leash to the ESD jack on the front side of the FCC

(see

Preventing Electrostatic Discharge, on page

bare metal surface on the FCC.

Step 2

Align the PM slot cover with the empty PM slot in the power tray.

Step 3

Insert the two tabs on the top of the PM slot cover into the two holes on the top of the PM slot.

Step 4

Push in the top of the PM slot cover gently until it clicks into place.

Figure 35: PM Slot Cover on the Front of a Power Tray — DC Power Tray Shown

This section describes how to connect the AC input power cords to the power modules and includes the

following topics:

Ensure that there is a readily accessible disconnect device incorporated in the building's installation wiring.

Before connecting AC input power cords to the power system, make sure that the input power cords are

Caution

not energized.

11). You can also connect the ESD-preventive wrist strap leash to any

Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Guide

Installing AC Input Power Cords

Table of Contents