Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Manual page 46

Installing the Rear Exterior Cosmetics
Step 5
Attach the exhaust plenum bracket to the FCC (cutouts facing up) using six pan-head screws, three screws each side.
Before installing the bracket, remove the topmost screw on each of the vertical troughs.
Step 6 Tighten the two 8-32 screws on the filler panel (that you previously installed) securely to the FCC.
Figure 19: Exhaust Plenum Bracket
1 Exhaust plenum bracket
Step 7
Attach the three door hinges and the three door latches by using two pan-head screws each
Hinges, Latches, and Retention
Step 8 Align the rear door with the three door hinges on the FCC
drop into position onto the hinge attachment pins.
We recommend that you use two people to lift the door onto the FCC.
Note
Step 9 Attach the grounding cable to the rear door (step 7).
a) Insert and tighten one pan-head screw to attach one end of the ground cable to the inside of the door.
Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Guide
32
Brackets).
(Figure 15: Attaching the Front
Installing the Power Enclosure, Power Trays, and Exterior Cosmetics
2 Six pan-head screws (three per side)
(Figure 17: Rear Door Trough
Door). The door will then