Removing A Power Module Slot Cover; Prerequisites; Steps - Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Manual

Removing and Replacing Chassis Components
Note The screws that attach a power tray to the power enclosure are relied upon for power tray bonding and
grounding.

Removing a Power Module Slot Cover

This section describes how to remove a PM slot cover from a PM slot in an AC or DC power tray.

Prerequisites

Before performing this task, you must first remove the top grille on the front side of the FCC, if installed See
the Removing the Front Exterior Cosmetics, on page

Steps

To remove a PM slot cover from the front of a power tray, follow these steps:
Step 1 Gently pinch the tabs on the top of the PM slot cover to partially detach the slot cover from the slot.
Step 2 Slide the PM slot cover out by removing the tabs on the bottom of the PM slot cover from the two holes on the bottom
of the slot.
Figure 61: PM Slot Cover on the Front of a Power Tray — DC Power Tray Shown
Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Guide
Removing a Power Module Slot Cover
88.
101