Table of Contents
Advertisement
Removing an SC or SC-SW Card
Steps
To remove an SC or SC-SW card, follow these steps:
Step 1
Attach the ESD-preventive wrist strap to your wrist and connect its leash to one of the two ESD jacks on the rear side
of the FCC (see
leash to any bare metal surface on the FCC.
Step 2
Identify the card to be removed from the card cage. Remove any cables connected to the front panel of the card.
Step 3
Use the number-2 Phillips screwdriver or number-2 common (flat-head) screwdriver to turn the two captive screws on
the front panel of the card counterclockwise to loosen the card from the slot.
Figure 70: Removing a Shelf Controller Card — SC-SW Card Shown
Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Guide
118
Preventing Electrostatic Discharge, on page
Removing and Replacing Chassis Components
11). You can also connect the ESD-preventive wrist strap
Advertisement
Table of Contents
