Table of Contents
Advertisement
Removing and Replacing Chassis Components
Steps
Follow these steps to remove the power enclosure from the FCC.
Step 1
Disconnect the two D-Sub connector cables from the PCMs on the rear of the power enclosure.
Step 2
Untighten the two captive screws on each side of the power enclosure and the three captive screws on the front flanges.
Step 3
Standing in front of the FCC, slide the power enclosure towards you, grasping it with one hand on the side of the power
shelf and the other hand underneath it for support.
Step 4
Carefully lift the power enclosure and remove it completely from the FCC.
Figure 65: Removing the Power Enclosure
1
Power enclosure
Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Guide
Removing the Power Enclosure
3
Side captive screws (two per side)
109
Advertisement
Table of Contents
Need help?
Do you have a question about the Network Convergence System 6000 Fabric Card Chassis and is the answer not in the manual?
Questions and answers