Installing The Tie-Down Bar - Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Manual

Installing the Power Components
AC Power System
Figure 26: Rack Mounting the AC PDU in a 19-Inch Rack

Installing the Tie-Down Bar

A 19-inch tie-down bar can be used to add strain relief for input power cables from the AC PDUs or cables
routed from a raised floor. The following figure shows holes for two 10-32 x 0.50 inch screws that are
pre-drilled on the FCC for attaching a tie-down bar.
Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Guide
42