Table of Contents
Advertisement
Removing an S2 Fabric Card
Prerequisites
The required prerequisites for removing an FC are:
• Identify the FC to be removed and check the fabric plane it is configured on.
• Shut down the fabric plane, if configured, to avoid traffic loss. The following example shows how to
shut down plane X (where X is in the range of 0 to 3).
config
controller fabric plane X
shutdown
commit
• Open the chassis door.
Required Tools and Equipment
• ESD-preventive wrist strap
• Number-2 Phillips screwdriver or Number-2 common (flat-head) screwdriver
Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Guide
122
Removing and Replacing Chassis Components
Advertisement
Table of Contents
Need help?
Do you have a question about the Network Convergence System 6000 Fabric Card Chassis and is the answer not in the manual?
Questions and answers