Steps; Removing The Fcc Ground Cable - Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Manual

Removing and Replacing Chassis Components

Steps

To remove a power module from the front of a power tray, follow these steps:
Step 1
Attach the ESD-preventive wrist strap to your wrist and connect its leash to the ESD jack on the front side of the FCC
(see Preventing Electrostatic Discharge, on page
bare metal surface on the FCC.
Step 2
Using the screwdriver, unscrew the ejector lever screw.
Figure 62: Removing a PM from a Power Tray
1 Ejector lever screw
2 Ejector lever
Step 3 Rotate the ejector lever down to unseat the PM.
Step 4 Slide the PM out of its bay in the power tray while supporting it with your other hand.

Removing the FCC Ground Cable

This section describes how to remove the FCC ground cable on the Cisco NCS 6000 FCC.
11). You can also connect the ESD-preventive wrist strap leash to any
Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Guide
Removing the FCC Ground Cable
3 Power module (PM)
103