Installing The Power Enclosure; Required Tools And Equipment - Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Manual

Installing the Power Enclosure

Usually, it is not necessary to remove the power enclosure although it is field-serviceable. For information
Note
about removing the power enclosure components, see the
99 section.
Figure 5: FCC Power Enclosure — Front and Rear Views
1
2
Installing the Power Enclosure
This section describes how to install the power enclosure in the Cisco NCS 6000 FCC.

Required Tools and Equipment

• 6-inch, Number-2 Phillips screwdriver
• Power enclosure (Cisco PID NCS-F-PWR-SHELF)
Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Guide
14
Four power tray slots for AC or DC power trays
Two PCMs
Installing the Power Enclosure, Power Trays, and Exterior Cosmetics
Replacing an AC or DC Power Tray, on page
3 PCM I/O power switches (one per PCM)