Prerequisites; Required Tools And Equipment; Steps - Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Manual

Prerequisites

Always use an electrostatic (ESD) wrist strap when handling SC or SC-SW cards.
Caution
Prerequisites
Before performing this task, open the cosmetic doors, if installed.

Required Tools and Equipment

• ESD-preventive wrist strap
• Number-2 Phillips screwdriver or number-2 common (flat-head) screwdriver
• SC card (Cisco PID NCS-F-SC) or SC-SW card (Cisco PID NCS-F-SCSW)

Steps

To install an SC or SC-SW card, follow these steps:
Step 1 Attach the ESD-preventive wrist strap to your wrist and connect its leash to one of the two ESD jacks on the rear side
of the FCC (see
bare metal surface on the FCC.
Step 2 Remove the card from its antistatic packaging.
Step 3 Orient the card according to the up arrow on the faceplate.
Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Guide
72
Figure 4: ESD Jack, on page
Installing the Shelf Controller Cards and Fabric Cards
12). You can also connect the ESD-preventive wrist strap leash to any