Table of Contents
Advertisement
S2 Fabric Card LEDs
• The 32 CXP LEDs indicate the status of the CXP links. Each LED is a bi-color red and green LED.
Note that each S2 FC slot must be configured as a fabric instance for the CXP LED to light up. For
example:
controller fabric plane 0
instance 0
location F0/FC0
Table 11: S2 Fabric Card LED Indicators
LED
STATUS
ATTN
CXP (0-31)
To verify which card needs attention, the Attention LED can be lit using the hw-module attention-led
Note
location command.
If the installed or replaced FC fails to operate or power on after installation:
• Ensure that the card is seated firmly in the FCC slot. One easy way to verify physical installation is to
see whether the front faceplate of the FC is even with the fronts of the other cards installed in the card
cage.
• Ensure that the ejector levers are latched and that the captive screws are fastened properly. If you are
uncertain, unlatch the levers, loosen the screws, and attempt to reseat the FC.
• Examine the power system to see whether the FCC is receiving power.
Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Guide
84
LED Color
Description
Green
The card is properly installed and no faults are detected.
Yellow
The software initialization is in progress during bootup or a fault
exists on the board.
Flashing yellow
The card is not fully seated or the slot has detected a parity error.
(slow)
Off
No power is applied to the card.
Blue
On: The card needs attention.
Off: The card does not require attention.
Green
The port is correctly connected to the S13 FC or UFC on the
LCC.
Red
One or more links are down. For troubleshooting information,
see the
Cisco NCS 6000 Series
Off
The CXP/CXP2 module is not present or is not fully inserted in
the card.
Installing the Shelf Controller Cards and Fabric Cards
System Administration Command Reference for the
Routers.
Advertisement
Table of Contents
