Installing The Exterior Cosmetics - Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Manual

Installing the Exterior Cosmetics

Caution Use care not to bend the
handles.
Figure 11: Installing a Power Tray into the Power Enclosure — DC Power Tray Shown
Step 3 Use the screwdriver to loosely tighten the four M4 x 10 mm screws that attach the power tray to the power enclosure.
Step 4
Use the torque screwdriver to tighten the four screws to a torque value of 15 in-lb (1.69 N-m) to 20 in-lb (2.26 N-m).
The screws that attach a power tray to the power shelf are relied upon for power tray bonding and grounding.
Note
Installing the Exterior Cosmetics
This section describes how to install the exterior cosmetics on the Cisco NCS 6000 FCC and includes the
following topics:
For information about removing the external cosmetics, see the
87 section.
Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Guide
20
Installing the Power Enclosure, Power Trays, and Exterior Cosmetics
Removing the Exterior Cosmetics , on page