Verifying The Installation Of An Sc Or Sc-Sw Card - Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Manual

Table of Contents

Verifying the Installation of an SC or SC-SW Card

Step 5

Press the OIR buttons on the top and bottom of the card faceplate to release the ejectors (SC-SW card only).

Step 6

Carefully slide the card into the slot until the ejector levers meet the edges of the card cage, and then stop when the

ejector lever hooks catch the card cage. If they do not catch, try reinserting the card until the ejector lever hooks are fully

latched.

Step 7

Pivot both card ejector levers so that the openings on the card ejector cams at the top and bottom of the card pass over

the tabs on each side of the card cage slot.

Caution

Verify that the openings on the card ejector cams pass over the tabs; otherwise, one or both ejector levers

might bind when you attempt to close the ejector levers, thereby damaging or breaking one or both ejector

levers.

Step 8

Continue sliding the card into the card cage slot until the openings on the card ejector cams engage the tabs on each side

of the card cage slot.

Note

The SC-SW and SC cards both have guide pins that make initial contact with the backplane connector as you

slide the card into its slot. After the guide pins make contact, continue pushing on the card carrier until the card

ejector levers begin pivoting forward toward the handle in the card carrier.

Step 9

To seat the card in the backplane connector, grasp both card ejector levers and pivot them inward toward the handle in

the card carrier until they are flush against the front edge of the card carrier.

Step 10

Use the number-2 Phillips screwdriver or number-2 common (flat-head) screwdriver to turn the two captive screws on

the front panel of the card clockwise to seat the card firmly in the slot.

This section describes how to verify that an SC or SC-SW card is properly installed and is working correctly

in the Cisco NCS 6000 FCC.

Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Guide

Installing the Shelf Controller Cards and Fabric Cards

Table of Contents