Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Manual page 105

Removing and Replacing Chassis Components
c) Remove the exhaust plenum bracket by loosening and removing the six pan-head screws (three per side) on each
side of the plenum bracket. For DC installations, make sure that you disconnect the DC cables from the bracket first.
Figure 54: Removing the Exhaust Plenum Bracket — Rear of the FCC
1 Exhaust plenum bracket
d) Loosen and remove the two 8-32 screws on each filler panel.
Cisco Network Convergence System 6000 Fabric Card Chassis Hardware Installation Guide
Removing the Front Exterior Cosmetics
2 Six pan-head screws (three per side)
91