Honda Civic 1998 Service Manual page 1406

r,i
I
6.
lnstallthe new SRS unit.
TORX BOLTS
9.8 N.m 11.0 kgf.m, 7.2 lbfft)
Uso a Torx T30 bh.
Replace.
SRS MAIN HARNESS
18P CONNECTOR
7 .
9.8 N.m (1.0 kgtm.7.2lbtftl
Uso a Torx T30 bit.
Replace.
Connect the SRS main harness 18P connector to the
SRS unit; push it into position until it clicks
I n s t a l l t h e S R S u n i t c o v e r s ( r i g h t a n d l e f t ) . M a k e
sure the covers snap together in the middle
8.
TORX BOLTS
1 0 .
9. Reconnect tho drivgr's airbr€ 2P :onnector lo the
cable reel 2P conn€ctor, than rernstall the access
panel on the steering r*reel-
Reconnect the front passenger's ai.bag conneclor
to the SRS main harness.
Reconnect the battery positive cable, th€n lho n6ga-
tive cable.
After installing the SRS unit, confirm proper system
operation: Turn the ignition switch ON (ll); the SRS
indicator light should come on for about six seconds
and then go off.
1 1 .