Programming a cycle
4.6 Contour turning
Procedure for deleting a contour element
4.6.5
Contour call - CYCLE62
Function
The input creates a reference to the selected contour.
There are four ways to call the contour:
● Contour name.
● Labels; the contour is in the same program bracketed by labels.
● Subprogram; the contour is in the same subprogram.
● Labels in subprogram; the contour is in the same subprogram bracketed by labels.
Procedure
212
1.
Place the cursor on the contour element that you want to delete.
2.
Press the "Delete element" softkey.
3.
Press the "Delete" softkey.
1.
Select the part program to be edited in the "Program manager"
operating area.
2.
Press the "Open" softkey or the "INPUT" key to edit the part program
in the editor.
3.
Press the "Contour turning" softkey.
4.
Press the "Contour" and "Contour call" softkeys.
The "Contour Call" input window opens.
5.
Assign parameters to the contour selection.
Operating Manual, 01/2008, 6FC5398-7AP10-0BA0
HMI sl Turning