Display Active Zero Offset - Siemens SINUMERIK 840D sl Operating Manual

Setting up the machine
2.7 Work offsets
Coarse and fine offsets
Every work offset (G54 to G57, G505 to G599) consists of a coarse offset and a fine offset.
You can call the work offsets from any program (coarse and fine offsets are added together).
You can save the workpiece zero, for example, in the coarse offset, and then store the offset
that occurs when a new workpiece is clamped between the old and the new workpiece zero
in the fine offset.
2.7.2

Display active zero offset

The current active offsets and all active system offsets are displayed for all set-up axes in
the "Work Offset - Active" window.
This window is generally used only for monitoring.
Display of active work offsets
Work offsets
Basic reference
Total base WO
G500
Programmed WO
Cycle reference
Total WO
The availability of the offsets depends on the setting.
62
Display of active system offsets. You can alter the data under certain
circumstances, i.e. you can correct a zero point.
Access to the system offsets is protected via a keyswitch.
Display of all active base offsets, as well as rotation, scaling and
mirroring.
You cannot edit these values here.
Display of all work offsets activated with G54 - G599, as well as
rotation, scaling and mirroring.
You cannot edit these values here.
Display of all additional work offsets programmed with $P_PFRAME=
as well as rotation, scaling and mirroring.
Display of all additional work offsets activated via
$MC_MM_SYSTEM_FRAME_MASK.
Display of the active work offset, representing the sum of all work
offsets, as well as rotation, scaling and mirroring.
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Operating Manual, 01/2008, 6FC5398-7AP10-0BA0
HMI sl Turning