Siemens SINUMERIK 840D sl Operating Manual page 297

Column heading
Holder angle/
Width/
Tip width/
Tip angle/
Pitch
Drill hole rad.
N
Tip length
Icons in the tool list
Icon/
Designation
Tool type
Red "X"
Yellow triangle pointing
downward
Yellow triangle pointing
upward
Green border
Magazine/location number
Green double arrow
Gray double arrow
Red "X"
HMI sl Turning
Operating Manual, 01/2008, 6FC5398-7AP10-0BA0
Meaning
Reference direction for holder angle
Specifies the cutting direction.
Holder angle for Type 500 - rougher and Type 510 - finisher. In addition to
the holder angle, the cutting tip angle is also specified.
Cutting edge for Type 150 - side milling cutter and Type 151 - saw
Tip width for Type 520 - plunge cutter and Type 530 - cut-off tool
Tip angle for Type 200 - twist drill and Type 220 - center drill
Pitch for Type 240 - tap
Drilling radius for Type 560 - rotary drill. Holder angle and cutting tip angle
are fixed.
Number of teeth for Type 110 - ball end mill for cylindrical die-sinking
cutter, Type 111 - ball end mill for tapered die-sinking cutter, Type 120 -
end mill, Type 121 - end mill with corner rounding, Type 130 - angle head
cutter, Type 140 - facing tool, Type 150 - side mill, Type 155 - bevel
cutter, Type 156 - bevel cutter with corner rounding, and Type 157 -
tapered die-sinking cutter.
Tip length of a cutting tool or grooving cutter
The tip length is required for displaying the tools during the simulation of
the program processing.
Meaning
The tool is disabled.
The prewarning limit has been reached.
The tool is in a special state.
Place the cursor on the marked tool. A tool tip will
provide a brief description.
The tool is preselected.
The magazine location is positioned at the change
position.
The magazine location is positioned at the loading
position.
The magazine location is disabled.
Tool management
7.5 Tool list
297