Siemens SINUMERIK 840D sl Operating Manual page 196

Programming a cycle
4.5 Rotate
Parameter
Infeed (only for ∇ and ∇
+ ∇∇∇)
Thread
X0
Z0
X1 or
X1α
Z1
LW
or
LW2
or
LW2 = LR
LR
H1
DP
or
αP
D1 or ND
(only for ∇ and
∇ + ∇∇∇)
196
Description
Linear:
•
Infeed with constant cutting depth
Degressive:
•
Infeed with constant cutting cross-section
Internal thread
•
External thread
•
Reference point in X ∅ (abs, always diameter)
Reference point in Z (abs)
End point X ∅ (abs) or end point in relation to X0 (inc) or
Thread taper
Incremental dimensions: The sign is also evaluated.
End point of the thread (abs) or thread length (inc)
Incremental dimensions: The sign is also evaluated.
Thread advance (inc)
The starting point for the thread is the reference point (X0, Z0) displaced by the
thread advance W. The thread advance can be used if you wish to begin the
individual cuts slightly earlier in order to produce a precise start of thread as well.
Thread run-in (inc)
The thread run-in can be used if you cannot approach the thread from the side and
instead have to insert the tool into the material (e.g. lubrication groove on a shaft).
Thread run-in = thread run-out (inc)
Thread run-out (inc)
The thread run-out can be used if you wish to retract the tool obliquely at the end
of the thread (e.g. lubrication groove on a shaft).
Thread depth (inc)
Infeed slope as flank (inc) – (alternative to infeed slope as angle)
DP > 0: Infeed along the rear flank
DP < 0: Infeed along the front flank
Infeed slope as angle – (alternative to infeed slope as flank)
α > 0: Infeed along the rear flank
α < 0: Infeed along the front flank
α = 0: Infeed at right angle to cutting direction
If you wish to infeed along the flanks, the maximum absolute value of this
parameter may be half the flank angle of the tool.
Infeed along the flank
Infeed with alternate flanks (alternative)
Instead of infeed along one flank, you can infeed along alternate flanks to avoid
loading the same tool cutting edge at all times, and thus increase the tool life.
α > 0: Start at rear flank
α < 0: Start at front flank
First infeed depth or number of roughing cuts
The respective value is displayed when you switch between the number of
roughing cuts and the first infeed.
Operating Manual, 01/2008, 6FC5398-7AP10-0BA0
Unit
mm
mm
mm or
degrees
mm
mm
mm
mm
mm
mm
Degrees
mm
HMI sl Turning