Machining the workpiece
3.10 Simulating a machining operation
3.10.8
Program control during the simulation
3.10.8.1
Changing the feedrate
You can change the feedrate at any time during the simulation.
You can track the changes in the dialog line.
Note
If you are working with the "Simultaneous recording" function, the override rotary switch on
the control panel is used.
Procedure
124
1.
Simulation is started.
2.
Press the "Program control" softkey.
3.
Press the "Override +" or "Override -" softkey to increase or decrease
the feedrate by 5%.
- OR -
Press the "Override 100%" softkey to set the feedrate to the maximum
value.
- OR -
4.
Press the "<<" softkey to return to the main screen and perform the
simulation with changed feedrate.
Operating Manual, 01/2008, 6FC5398-7AP10-0BA0
HMI sl Turning