Siemens SINUMERIK 840D sl Operating Manual page 202

Programming a cycle
4.5 Rotate
Parameter
X1 or X1α
Z1
P1
X2 or X2α
Z2
P2
X3
Z3
LW
LR
H1
DP or αP
D1 or ND
rev
NN
VR
α0
N
DA
1) Parameter description refers to plane G18; plane selection G17 or G19 possible in selection field
(MD 52006: $MCS_DISP_PLANE_TURN)!
202
Description
Intermediate point 1 X ∅ (abs) or
•
Intermediate point 1 in relation to X0 (inc) or
•
Thread taper 1
•
Incremental dimensions: The sign is also evaluated.
Intermediate point 1 Z (abs) or
•
Intermediate point 1 in relation to Z0 (inc)
•
Thread pitch 2
Intermediate point 2 X ∅ (abs) or
•
Intermediate point 2 in relation to X1 (inc) or
•
Thread taper 2 (abs or inc)
•
Incremental dimensions: The sign is also evaluated.
Intermediate point 2 Z (abs) or
•
Intermediate point 2 in relation to Z1 (inc)
•
Thread pitch 3
End point X ∅ (abs) or
•
End point 3 in relation to X2 (inc) or
•
Thread taper 3
•
End point Z ∅ (abs) or
•
End point with reference to Z2 (inc)
•
Thread run-in
Thread run-out
Thread depth
Infeed slope (flank) or infeed slope (angle)
Infeed along a flank
•
Infeed with alternating flanks
•
First infeed depth or number of roughing cuts - (only for ∇ and ∇ + ∇∇∇)
Finishing allowance in X and Z – (only for ∇ and ∇ + ∇∇∇)
Number of noncuts
Return distance
Starting angle offset
Number of threads
Thread changeover depth
Operating Manual, 01/2008, 6FC5398-7AP10-0BA0
Unit
mm
Degrees
mm/rev
mm
Degrees
mm/rev
HMI sl Turning