Changing The Call Type For A Db - Siemens SIMATIC S7 System Manual

95BSTEP 7 programming software
2.3 Easy-to-use tools
2.3.11

Changing the call type for a DB

36
STEP 7 allows you to easily create or change the
association of a DB for an instruction or an FB that is in
an FB.
 You can switch the association between different DBs.
 You can switch the association between a single-
instance DB and a multi-instance DB.
 You can create an instance DB (if an instance DB is
missing or not available).
You can access the "Change call type" command either
by right-clicking the instruction or FB in the program
editor or by selecting the "Block call" command from the
"Options" menu.
The "Call options" dialog allows
you to select a single-instance
or multi-instance DB. You can
also select specific DBs from a
drop-down list of available DBs.
S7-1200 Programmable controller
System Manual, 11/2011, A5E02486680-05