Editing A Block - Siemens SINUMERIK 840D sl Operating Manual

Teaching in a program

6.4 Editing a block

Transition behavior at the beginning and end of the spline curve
The following motion parameters are offered:
Parameter
Start
BAUTO
BNAT
BTAN
End
EAUTO
ENAT
ETAN
6.4 Editing a block
You can only overwrite a program block with a teach-in block of the same type.
The axis values displayed in the relevant window are actual values, not the values to be
overwritten in the block.
Note
If you wish to change any variable in a block in the program block window other than the
position and its parameters, then we recommend alphanumerical input.
Requirement
The program to be edited is selected.
282
Description
Automatic calculation
Curvature is zero or natural
Tangential
Automatic calculation
Curvature is zero or natural
Tangential
Operating Manual, 01/2008, 6FC5398-7AP10-0BA0
HMI sl Turning