Tool List - Siemens SINUMERIK 840D sl Operating Manual

Tool management

7.5 Tool list

7.5 Tool list
All parameters and functions that are required to create and set up the tools are displayed in
the tool list.
Each tool is uniquely identified by the tool identifier and the replacement tool number.
Tool parameters
Column heading
Location
* If activated in magazine
selection
Type
Tool name
ST
D
Length X, length Z
Radius
296
Meaning
Magazine/location number
•
The following icons can also be displayed for other magazine types (e.g.
for a chain):
•
•
*
*
Tool type
Specific tool offset data is displayed depending on the tool type
(represented as an icon).
The icon identifies the position of the tool; this was selected when the tool
was created.
You have the option of changing the tool position with the aid of the
"Select" key.
The tool is identified by the name and the replacement tool number. You
can enter the name as text or number.
Replacement tool number (for replacement tool strategy).
Cutting edge number
Tool length
Geometry data length X and length Z
Tool radius
The magazine location numbers.
The magazine number is specified first, followed by the location
number.
If there is only one magazine, only the location number is displayed.
Spindle location as an icon.
Locations for gripper 1 and gripper 2 (applies only when a spindle with
dual gripper is used) as icons.
Operating Manual, 01/2008, 6FC5398-7AP10-0BA0
HMI sl Turning