Contour Call (Cycle62) - Only For G Code Program - Siemens SINUMERIK 840D Operating Manual

Hide thumbs Also See for SINUMERIK 840D:
Table of Contents

Advertisement

Procedure for changing a contour element
Procedure for deleting a contour element
8.3.6

Contour call (CYCLE62) - only for G code program

Function
The input creates a reference to the selected contour.
There are four ways to call the contour:
1. Contour name
2. Labels
3. Subprogram
4. Labels in the subprogram
Milling
Operating Manual, 03/2010, 6FC5398-7CP20-1BA0
1.
Open the part program or ShopMill program to be executed.
2.
With the cursor, select the program block where you want to change
the contour. Open the geometry processor.
The individual contour elements are listed.
3.
Position the cursor at the position where a contour element is to be
inserted or changed.
4.
Select the desired contour element with the cursor.
5.
Enter the parameters in the input screen or delete the element and
select a new element.
6.
Press the "Accept" softkey.
The desired contour element is inserted in the contour or changed.
1.
Open the part program or ShopMill program to be executed.
2.
Position the cursor on the contour element that you want to delete.
3.
Press the "Delete element" softkey.
4.
Press the "Delete" softkey.
The contour is in the calling main program.
The contour is in the calling main program and is limited by the labels that have been
entered.
The contour is located in a subprogram in the same workpiece.
The contour is in a subprogram and is limited by the labels that have been entered.
Programming technological functions (cycles)
8.3 Contour milling
337

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinumerik828d

Table of Contents