Executing An Mda Program - Siemens SINUMERIK 840D sl Operating Manual

2.11.3

Executing an MDA program

Proceed as follows
When executing the G-code commands, you can control the sequence as follows:
● Executing the program block-by-block
● Testing the program
● Setting the test-run feedrate
HMI sl Turning
Operating Manual, 01/2008, 6FC5398-7AP10-0BA0
1. Select the "Machine" operating area.
2. Press the "MDA" key.
The MDA editor opens.
3. Input the desired G-code commands using the operator's keyboard.
4. Press the "CYCLE START" key.
The control executes the input blocks.
Settings under program control
Settings under program control
Setting up the machine
2.11 MDA
83