Magazine - Siemens SINUMERIK 840D sl Operating Manual

7.8

Magazine

Tools are displayed with their magazine-related data in the magazine list. Here, you can take
specific actions relating to the magazines and the magazine locations.
Individual magazine locations can be location-coded or disabled for existing tools.
Tool parameters
Column heading
Location
* If activated in magazine
selection
Type
Tool name
ST
D
G
Mag.loctype
Tool.loctype
Ü
P
HMI sl Turning
Operating Manual, 01/2008, 6FC5398-7AP10-0BA0
Meaning
Magazine/location number
•
*
The following icons can also be displayed for other magazine types (e.g.
for a chain):
*
•
•
Tool type
Depending on the tool type (represented by an icon), certain tool offset
data is enabled.
The tool is identified by the name and number of the replacement tool
(ST). You can enter the name as text or number.
Number of the replacement tool.
Cutting edge number
Disabling of the magazine location.
Display of magazine location type.
Display of tool location type.
Marking a tool as oversized. The tool occupies two half locations left, two
half locations right, one half location top and one half location bottom in a
magazine.
Fixed location coding.
The tool is permanently assigned to this magazine location.
The magazine location numbers.
The magazine number is specified first, followed by the location
number.
If there is only one magazine, only the location number is displayed.
Spindle location as an icon.
Locations for gripper 1 and gripper 2 (applies only when a spindle
with dual gripper is used) as icons.
Tool management
7.8 Magazine
311