Siemens SINUMERIK 840D sl Operating Manual page 180

Programming a cycle
4.5 Rotate
Parameter
Z0
X1
Z1
D
UX
UZ
FS1...FS3 or R1...R3
XM
ZM
α1
α2
1) Parameter description refers to plane G18; plane selection G17 or G19 possible in selection field
(MD 52006: $MCS_DISP_PLANE_TURN)!
180
Description
Reference point in Z (abs)
End point X (abs) or end point X in relation to X0 (inc)
End point Z (abs) or end point Z in relation to Z0 (inc)
Maximum depth infeed – (not for finishing)
Finishing allowance in X – (not for finishing)
Finishing allowance in Z – (not for finishing)
Chamfer width (1...3) or rounding radius (1...3) - (not for stock removal 1)
Parameter selection of intermediate point
The intermediate point can be determined through position specification or angle.
The following combinations are possible - (not for stock removal 1 and 2)
• XM ZM
XM α1
•
XM α2
•
α1 ZM
•
α2 ZM
•
α1 α2
•
Intermediate point X ∅ (abs) or intermediate point X in relation to X0 (inc)
Intermediate point Z (abs) or intermediate point Z in relation to Z0 (inc)
Angle of the 1st edge
Angle of the 2nd edge
Operating Manual, 01/2008, 6FC5398-7AP10-0BA0
Unit
mm
mm
mm
Degrees
Degrees
HMI sl Turning