Displaying The Current Program Block; Current Block Display - Siemens SINUMERIK 840D sl Operating Manual

3.3

Displaying the current program block

3.3.1

Current block display

The window of the current block display shows you the program blocks currently being
executed.
Display of current program
The following information is displayed in the running program:
● The workpiece name or program name is entered in the title row.
● The program block which is just being processed appears colored.
Editing a program directly
In the Reset state, you can edit the current program directly.
HMI sl Turning
Operating Manual, 01/2008, 6FC5398-7AP10-0BA0
5. Press the "SINGLE BLOCK" key again, if the machining is not
supposed to run block-by-block.
The key is deselected again.
If you now press the "CYCLE START" key again, the program is
executed to the end without interruption.
1. Press the "INSERT" key.
2. Place the cursor at the relevant position and edit the program block.
Direct editing is only possible for part programs in the NC memory, not
for external execution.
3. Press the "INSERT" key to exit the program and the editing mode
again.
Machining the workpiece
3.3 Displaying the current program block
89