Modifying The Viewport; Displaying Simulation Alarms - Siemens SINUMERIK 840D sl Operating Manual

Machining the workpiece
3.10 Simulating a machining operation
3.10.9.4

Modifying the viewport

If you would like to move, enlarge or decrease the size of the segment of the graphical
display, e.g. to view details or display the complete workpiece, use the magnifying glass.
Using the magnifying glass, you can define your own segment and then increase or
decrease its size.
Requirement
The simulation or the simultaneous recording is started.
Procedure
3.10.10

Displaying simulation alarms

Special alarms might occur during simulation. If an alarm occurs during a simulation run, a
window opens in the operating window to display it.
The alarm overview contains the following information:
● Date and time
● Deletion criterion
● Alarm number
● Alarm text
128
1. Press the "Details" softkey.
2. Press the "Magnifying glass" softkey.
A magnifying glass in the shape of a rectangular frame appears.
3. Press the "Magnify +" or <+> softkey to enlarge the frame.
- OR -
Press the "Magnify -" or <-> softkey to reduce the frame.
- OR -
Press a cursor key to move the frame up, down, left or right.
Specifies with which softkey the alarm is acknowledged
Operating Manual, 01/2008, 6FC5398-7AP10-0BA0
HMI sl Turning