Program Management; Overview - Siemens SINUMERIK 840D sl Operating Manual

Program management

8.1

Overview

You can access these programs at any time via the Program Manager for execution, editing,
copying, or renaming. Programs that you no longer require can be deleted to release their
storage space.
NOTICE
Execution from USB FlashDrive
Direct execution from a USB FlashDrive is not recommended.
There is no protection against contact problems, falling out, breakage through knocking or
unintentional removal of the USB FlashDrive during operation.
Disconnecting it during operation will result in the stopping of the machining and thus to the
workpiece being damaged.
Storage for programs
Possible storage locations are:
● NC
● Local drive
● Network drives
● USB drives
HMI sl Turning
Operating Manual, 01/2008, 6FC5398-7AP10-0BA0
Software options
You need the "Additional 256 MB HMI user memory on CF card of NCU"
option in order to display the "Local drive" softkey.
To set up network drives, you need the "Network drive management" option.
8
317