Teach-In Via Windows; General - Siemens SINUMERIK 840D sl Operating Manual
Hide thumbs
Also See for SINUMERIK 840D sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
6.3.1
Teach-in via Windows
6.3.1.1
General
The cursor must be positioned on an empty line.
The windows for pasting program blocks contain input and output fields for the actual values
in the WCS. Depending on the default setting, selection fields with parameters for motion
behavior and motion transition are available.
When first selected, the input fields are empty unless axes were already traversed before the
window was selected.
All data from the input/output fields are transferred to the program via the "Accept" softkey.
Requirement
"AUTO" mode: The program to be edited is selected.
Proceed as follows
HMI sl Turning
Operating Manual, 01/2008, 6FC5398-7AP10-0BA0
1
Select the "Machine" operating area.
2.
Press the "AUTO" or "MDA" key.
...
3.
Press the "TEACH IN" key.
4.
Press the "Teach prog." softkey.
5.
Use the cursor and input keys to position the cursor at the desired
point in the program.
If an empty row is not available, insert one.
6.
Press the softkeys "Rap. tra. G0", "Straight line G1", or Circ. interm.
pos. CIP" and "Circ. end pos. CIP".
The relevant windows with the input fields are displayed.
7.
Traverse the axes to the relevant position.
Teaching in a program
6.3 Inserting a block
277
Advertisement
Table of Contents
