Positioning Axes; Default Settings For Manual Mode - Siemens SINUMERIK 840D sl Operating Manual

2.9.4

Positioning axes

In order to implement simple machining sequences, you can traverse the axes to certain
positions in manual mode.
The feedrate / rapid traverse override is active during traversing.
Procedure
2.9.5

Default settings for manual mode

Specify the configurations for manual mode in the "Settings for manual operation" window.
Presettings
Settings
Type of feedrate
Default feedrate G94
Default feedrate G95
Variable increment
Spindle speed
HMI sl Turning
Operating Manual, 01/2008, 6FC5398-7AP10-0BA0
1. If required, select a tool.
2. Select the "JOG" operating mode.
3. Press the "Positions" softkey.
4. Enter the target position or target angle for the axis or axes to be
traversed.
5. Specify the desired value for the feedrate F.
- OR -
Press the "Rapid traverse" softkey.
The rapid traverse is displayed in field "F".
6. Press the "CYCLE START" key.
The axis is traversed to the specified target position.
If target positions were specified for several axes, the axes are
traversed simultaneously.
Description
Here, you select the type of feedrate.
G94: Axis feedrate/linear feedrate
•
G95: Rev. feedrate
•
Enter the desired feedrate in mm/min.
Enter the desired feedrate in mm/r.
Enter the desired increment for axis traversal by variable increments.
Enter the desired spindle speed in rpm.
Setting up the machine
2.9 Manual mode
77