Overstore - Siemens SINUMERIK 840D sl Operating Manual

3.8

Overstore

This function allows you to overstore technological parameters (for example, auxiliary
functions, axis feed, spindle speed, programmable instructions, etc.) for a program run in the
main memory of the NCK.
When next started, the program will be executed as originally programmed.
Requirement
The program to be corrected is in the Stop or Reset mode.
Procedure
HMI sl Turning
Operating Manual, 01/2008, 6FC5398-7AP10-0BA0
3. Press the "Prog. cntrl." and "Skip blocks" softkeys.
The "Program control" window appears and shows a list of block
levels.
1. Open the program in the "AUTO" mode.
2. Press the "Overstore" softkey.
The "Overstore" window opens.
3. Enter the required data and NC block.
Machining the workpiece
3.8 Overstore
105