⚫
PTZ type: There are two types: local/remote. Please select local mode if you are connect RS485
cable to connect to the Speed dome (PTZ). Please select remote mode if you are connecting to the
network PTZ camera.
⚫
Protocol: Select corresponding PTZ protocol(such as PELCOD)
⚫
Address: Default address is 1.
⚫
Baud rate: Select corresponding baud rate. Default value is 9600.
⚫
Data bit: Select corresponding data bits. Default value is 8.
⚫
Stop bit: Select corresponding stop bits. Default value is 1.
⚫
Parity: There are three options: odd/even/none. Default setup is none.
If you are connecting to network PTZ, the PTZ type shall be remote. See Figure 3-80.
Figure 3-79
77