Event - Unisight EmPower NVR User Manual

Check the Enable box to enable P2P function and then click the Save button. When the Status shows
Online, the P2P registration is successful.
⚫
P2P is enabled by default.
⚫
To enable you to manage the device on the mobile APP, we will collect device information like IP
address, MAC address, device name and device SN. The collected information is only used for
remote device access.

4.11.3 Event

4.11.3.1 Video detect
4.11.3.1.1 Motion Detect
After analysis video, system can generate a video loss alarm when the detected moving signal reached
the sensitivity you set here.
The motion detect interface is shown as in Figure 4-60.
Figure 4-60
263