Unisight EmPower NVR User Manual page 279

Parameter
Record
channel
Record Delay
Alarm out
Latch
Show
message
Buzzer
Alarm upload
Message
Send Email
Tour
PTZ
Activation
Snapshot
Video Matrix
4.11.3.1.2
Video Loss
The video loss interface is shown as in Figure 4-66.
Please note video loss does not support anti-dither, sensitivity, region setup. For rest setups, please refer
to chapter 4.11.3.1.1 motion detect for detailed information.
Function
setup. If you click ESC button to exit the region setup interface
system will not save your zone setup.
System auto activates motion detection channel(s) to record once
an alarm occurs. Please note you need to set motion detect record
period and go to Storage-> Schedule to set current channel as
schedule record.
System can delay the record for specified time after alarm ended.
The value ranges from 10s to 300s.
Enable alarm activation function. You need to select alarm output
port so that system can activate corresponding alarm device when
an alarm occurs.
System can delay the alarm output for specified time after an
alarm ended. The value ranges from 1s to 300s.
System can pop up a message to alarm you in the local host
screen if you enabled this function.
Check the box here to enable this function. The buzzer beeps
when an alarm occurs.
System can upload the alarm signal to the center (Including alarm
center.
When 3G network connection is OK, system can send out a
message when motion detect occurs.
If you enabled this function, System can send out an email to alert
you when an alarm occurs.
You need to click setup button to select tour channel. System
begins 1-wiindow or multiple-window tour display among the
channel(s) you set to record when an alarm occurs. See Figure
4-64.
Here you can set PTZ movement when alarm occurs. Such as go
to preset X. See Figure 4-63.
Click setup button to select snapshot channel. See Figure 4-65.
This function is for motion detect only. Check the box here to
enable video matrix function. Right now system supports
one-channel tour function. System takes "first come and first
serve" principle to deal with the activated tour. System will process
the new tour when a new alarm occurs after previous alarm ended.
Otherwise it restores the previous output status before the alarm
activation.
266