Unisight EmPower NVR User Manual page 182

Step 2 Select the SNMP check box.
Step 3 Configure the parameyers. For details, see the following table.
Parameter
Version
SNMP Port
Read
Community/Write
Community
Trap Address
Trap Port
Read Only User
Read/Write User
Authentication
Password
Encryption Type
Step 4 Click OK to complete the configuration.
Step 5 View device info.
1) Run MIB Builder and MG-SOFT MIB Browser.
Figure 3-180
Description
Select the check box of the corresponding version.
System selects V3 by default. There might be risks for V1 and V2.
Enter the SNMP port number.
The read community/write community string supported by the program.
Enter the IP address of the PC installed with MG-SOFT MIB Browser. It
is the destination address to receive trap information from the device.
The destination port to receive trap information from the device.
Enter the read only username to access the NVR device.
Enter the read/write username to access the NVR device.
It includes MD5 and SHA. System automatically recognizes it after it is
enabled.
Enter the password for encryption and authentication. The password
shall be no less than 8 characters.
Select the encryption type. The default type is CBC-DES.
169