Unisight EmPower NVR User Manual page 259

4.11.2.2 Port
The connection interface is shown as in Figure 4-34.
Please refer to the following sheet for detailed information.
Parameter
Max connection
TCP port
UDP port
HTTP port
HTTPS
RTSP port
4.11.2.3 Wi-Fi AP
This function is available only for NVR devices with built-in Wi-Fi module. See the actual situation.
4.11.2.3.1 General Setup
The Wi-Fi AP interface is shown as in Figure 4-35. Select the Enable check box and you can set Wi-Fi
hotspot including SSID, encryption type, password, channel and gain, so that the Wi-Fi IPC can use the
hotspot to connect to the network.
Figure 4-34
Function
The max client login amount (such as WEB, platform, cellphone
and etc). The value ranges from 1 to 128(default).
The default value is 37777. You can input the actual port
number if necessary.
The default value is 37778. You can input the actual port
number if necessary.
The default value is 80. You can input the actual port number if
necessary.
Select the Enable check box and configure the port according to
your actual needs. The default value is 443. After HTTPS is
enabled, HTTP will be switched to HTTPS by force to transmit
data in a safer way.
The default value is 554.
246