Unisight EmPower NVR User Manual page 170

⚫
Wi-Fi working status: Here you can view current connection status.
Please note:
⚫
After successful connection, you can see Wi-Fi connection icon at the top right corner of the preview
interface.
⚫
When the hotspot verification type is WEP, system displays as AUTO since the device cannot detect
its encryption type.
⚫
System does not support verification type WPA and WPA2. The display may become abnormal for
the verification type and encryption type.
After device successfully connected to the Wi-Fi, you can view the hotspot name, IP address, subnet
mask, default gateway and etc. Right now system support TOTOLINK_N2200UP module.
3.8.1.5 Repeater
The device supports repeater function for front-end IPCs to effectively extend video transmission distance
and range.
Only some devices support this function.
Repeater is available for devices with built-in Wi-Fi module and the front-end IPC shall support repeater.
Binding Repeater
Step 1 Turn on the NVR device and IPCs, and then directly connect all the IPCs to the NVR device via
Wi-Fi.
Step 2 Enter from main menu > Setting > Network > Repeater.
Step1 The Repeater interface is displayed. See Figure 3-169.
Figure 3-168
157