Unisight EmPower NVR User Manual page 154


Finally, you can set the alarm input as the local alarm and then select the record channel. The
select channel begins alarm record when an alarm occurred. Please note system begins the
alarm record instead of the MD record if the local alarm and MD event occurred at the same
time.
⚫
Tour: Here you can enable tour function when an alarm occurs. System supports 1/8 -window tour.
Please go to chapter3.3.6.2 Display for tour interval setup. Please note the tour setup here has
higher priority than the tour setup you set in the Display interface. Once there two tours are both
enabled, system can enable the alarm tour as you set here when an alarm occurred. If there is no
alarm, system implements the tour setup in the Display interface.
⚫
Snapshot: You can enable this function to snapshot image when an alarm occurs.
⚫
Buzzer: Highlight the icon to enable this function. The buzzer beeps when an alarm occurs.
Figure 3-148
141