Unisight EmPower NVR User Manual page 282

Select a channel from the dropdown list. Click Add button, you can see an interface shown as below. See
Figure 4-70.
Select a channel from the dropdown list and then set preset. Click Add button and then set the
corresponding rule.
Note
Some smart camera does not need to add the preset. Please refer to the actual product for detailed
information.
Click OK button to complete the setup.
Note
⚫
The NVR supports general behavior analytics (IVS), human face detection, heat map, and people
counting. Different network camera supports different smart plans. Please refer to the actual product
for detailed information.
⚫
The general behavior analytics (IVS) and human face detection function cannot be valid at the same
time. For example, when add the IVS plan to the preset 1, the human face detection icon becomes
grey.
4.11.3.3 IVS (Behavior Analytics) (Optional)
Once the object state has reached the threshold, NVR can trigger an intelligent alarm.
Note
⚫
This function is for some series product only. Please refer to the actual product for detailed
information.
⚫
The IVS function and the human face detection function cannot be valid at the same time.
The IVS function environment shall meet the following requirements:
⚫
The object total size shall not be more than 10% of the whole video.
⚫
The object size on the video shall not be more than 10pixels*10 pixels. The abandoned object size
shall be more than 15pixels*15 pixels (CIF resolution). The object width shall not be more than 1/3 of
Figure 4-70
269