Unisight EmPower NVR User Manual page 292

Click to draw the rule.
Click OK to complete the rule setup.
For detailed setups, please refer to chapter 4.11.3.1.1 motion detect for detailed information.
4.11.3.3.9
Global Config
From main menu->Setup->Event->Behavior analytics->Global, you can go to the global configuration
interface. See the below figure.
⚫
Channel: Please select a channel from the dropdown list.
⚫
Preset: Select a preset you want to set the rule. Please note, you need to add a preset first,
otherwise, you cannot see the preset dropdown list. If there is no preset, you can draw a rule in
current channel.
⚫
Calibration zone:

Click Add area
and then click Delete zone button; you can remove the selected zone.

Select gauge type (vertical/level), you can set the corresponding length. You can draw three tilt
gauges and one horizontal gauge at the left pane of the interface.
⚫
Select Width/Height and then click Verify, you can draw a line in the calibration zone, and then you
can see its actual length.
⚫
Update preset: Click it to get the latest preset setup.
, you can draw a calibration zone at the left pane of the interface. Select a zone
Figure 4-84
279