Unisight EmPower NVR User Manual page 84

Set preview display mode, channel display sequence and tour setup.
⚫
Set preview display mode: On the preview interface, right click mouse, you can view right-click menu.
Now you can select preview window amount and channel.
⚫
Set channel display mode: On the preview interface, if you want to change channel 1 and channel 16
position, please right click channel 1 video window and then drag to the channel 16 video window,
release button, you can change channel 1 and channel 16 position.
⚫
Tour setup: Here you can set preview window channel display mode and interval. Please follow the
steps listed below.
From Main menu->Setting->System->Display->Tour, you can see an interface shown as in Figure 3-72.
Here you can set tour parameter.
⚫
Enable tour: Check the box here to enable tour function. The general tour supports all types of
window split mode.
⚫
Interval: Input proper interval value here. The value ranges from 1-120 seconds.
⚫
Motion tour type: System support 1/8-window tour. Please note you need to go to the main
menu->Setting->Event->Video detect->Motion detect to enable tour function.
⚫
Alarm tour type: System support 1/8-window tour. Please note you need to go to the main
menu->Setting->Event->Alarm to enable tour function.
⚫
Window split: It is to set window split mode.
Tips
On the navigation bar, click
Click Save button to save current setup.
3.3.6.5 Customized split
It is to set customized video split mode.
Figure 3-72
/ to enable/disable tour.
71