Unisight EmPower NVR User Manual page 255

Video/audio
Audio format
Sampling rate
Watermark
enable
4.11.1.3.2 Snapshot
The snapshot interface is shown as in Figure 4-29.
Please refer to the following sheet for detailed information.
Parameter
Snapshot type
Image size
Quality
Interval
Copy
4.11.1.3.3 Video Overlay
The video overlay interface is shown as in Figure 4-30.
You can enable or disable the video/audio. The main stream is
enabled by default. After enable the audio function, the record file
is composite file consisting of the video and audio. For the sub
stream 1, please enable video first and then enable audio
function.
Set audio encode format.
Note
Different series products support different audio encode mode.
Please refer to the actual interface for detailed information.
Audio sampling rate refers to the sampling amount within 1
second. The higher the value is, the better the audio is. The
default setup is 8K.
This function allows you to verify the video is tampered or not.
Here you can select watermark bit stream, watermark mode and
watermark character. Default character is DigitalCCTV. The max
length is 85-digit. The character can only include number,
character and underline.
Figure 4-29
Function
There are two modes: Regular (schedule) and Trigger.
⚫
Regular snapshot is valid during the specified period you
set.
⚫
Trigger snapshot only is valid when motion detect alarm,
tampering alarm or local activation alarm occurs.
It is the same with the resolution of the main stream.
It is to set the image quality. There are six levels.
It is to set snapshot frequency. The value ranges from 1s to 7s.
Or you can set customized value. The max setup is
3600s/picture.
Click it; you can copy current channel setup to other channel(s).
242