Storage - Unisight EmPower NVR User Manual

Parameter
Alarm
upload
Send
Email
Buzzer
Log
4.11.3.11 Alarm Out
The alarm output interface is shown as below. See Figure 4-104
Here you can set alarm output mode: auto/manual/stop.

4.11.4 Storage

4.11.4.1 Basic
It is to manage HDD storage space.
Step 4 From main menu->Setup->Storage->Basic.
Enter Basic interface. See Figure 4-44.
Step 5 Set parameters.
Function
System can upload the alarm signal to the center (Including alarm
center.
If you enabled this function, System can send out an email to alert you
when an alarm occurs.
Check the box here to enable this function. The buzzer beeps when an
alarm occurs.
Check the box here, system can record the network event alarm log.
Figure 4-104
Figure 4-105
292