Siemens RUGGEDCOM ROX II User Manual page 776

Chapter 17
Time Services
9. Add restrictions for the remote NTP servers. For more information, refer to
Restriction".
10. Enable and configure the NTP service. For more information, refer to
the NTP Service".
11. View the status of the NTP service. For more information, refer to
Status".
Section 17.2
Configuring the System Time and Date
To configure the system time and date, do the following:
1. Make sure the CLI is in Configuration mode.
2. Set the system time and date by typing:
admin set-system-clock time time-date
Where:
• time-date is the date time in the format YYYY-MM-DD HH:MM:SS
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 17.3
Configuring the System Time Zone
To configure the system time zone, do the following:
1. Make sure the CLI is in Configuration mode.
2. Set the system time zone by typing:
NOTE
The Etc/GMT time zones conform to the POSIX style and have their signs reversed from common
usage. In POSIX style, zones west of Greenwich Mean Time (GMT) have a positive sign, while zones
east of GMT have a negative sign.
admin timezone category category zone zone
Where:
• category is the time zone category
• zone is the time zone
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 17.4
Configuring the Local Time Settings
The local time settings configure the local clock on the device as the NTP time source.
730
Section 17.8.6.2, "Adding a Server
Section 17.5, "Enabling and Configuring
Section 17.6, "Viewing the NTP Service
Configuring the System Time and Date
RUGGEDCOM ROX II
CLI User Guide