Siemens RUGGEDCOM ROX II User Manual page 371

RUGGEDCOM ROX II
CLI User Guide
Serial Server
This chapter describes how to manage and configure the serial server, including serial ports, protocols, remote
hosts and the Device Address Tables.
NOTE
Serial server functions are dependent on the installation of a serial line module. For more information
about available serial line modules, refer to one of the following catalogs:
• RUGGEDCOM Modules Catalog for the RUGGEDCOM RX5000 series
https://support.industry.siemens.com/cs/ww/en/view/109748779
• RUGGEDCOM Modules Catalog for the RUGGEDCOM MX5000 series
https://support.industry.siemens.com/cs/ww/en/view/109748778
• RUGGEDCOM Modules Catalog for the RUGGEDCOM MX5000RE series
https://support.industry.siemens.com/cs/ww/en/view/109748780
CONTENTS
• Section 10.1, "Managing Serial Ports"
• Section 10.2, "Managing Serial Port Protocols"
• Section 10.3, "Managing Device Address Tables"
• Section 10.4, "Managing Serial Multicast Streaming"
• Section 10.5, "Managing Remote Hosts"
• Section 10.6, "Managing Local Hosts"
• Section 10.7, "Managing Remote Host Interfaces"
• Section 10.8, "Managing Local Host Interfaces"
Section 10.1
Managing Serial Ports
This section describes how to configure, monitor and manage serial ports on the device.
CONTENTS
• Section 10.1.1, "Viewing Serial Port Statistics"
• Section 10.1.2, "Viewing Transport Connection Statistics"
• Section 10.1.3, "Viewing DNP Device Table Statistics"
• Section 10.1.4, "Restarting the Serial Server"
• Section 10.1.5, "Resetting a Serial Port"
Managing Serial Ports
Chapter 10
Serial Server
325