Siemens RUGGEDCOM ROX II User Manual page 114

Chapter 4
Device Management
Parameter
url { url }
3. If the VPE feature key (VIRTUALM) was installed, reboot the device to reveal the virtualization features. For
more information, refer to
Section 4.9.2
Backing Up Files
To backup files stored on the device, do the following:
1. If the file's destination is a USB Mass Storage drive, insert the drive in the USB port on the device. For more
information, refer to the RUGGEDCOM RX5000/MX5000/MX5000RE Installation Guide.
2. Make sure the CLI is in Configuration mode.
Navigate to admin » backup-files and configure the following parameter(s) as required:
3.
NOTE
RUGGEDCOM ROX II supports implicit FTP over TLS (FTPS) URLs. Explicit FTP over TLS is not
supported.
Parameter
file-type { file-type }
file { file }
timestamp
url { url }
68
This parameter is mandatory.
Synopsis: A string 1 to 1024 characters long
The URL of the ROX II file to copy. Supported URIs are HTTP, SCP, SFTP, FTPS and FTP.
To install from a USB flash drive or microSD card (if applicable), the URL format is "usb://
{usb-device-name}/path-to-file-on-system" or "sd://sd-1//path-to-file-on-system". Run
"show chassis" to determine the name of the USB device. Note that only one single
partition is supported for either data medium.
For all other protocols, the format is "protocol://user:password@host:port/path-to-file". If
"port" is not specified, the default port for the protocol is used.
This parameter is mandatory.
Section 4.5, "Rebooting the
Synopsis: { config, featurekey, logfiles, rollbacks, licenses, logarchive }
The file types to copy.
This parameter is mandatory.
Synopsis: A string 1 to 255 characters long
The name of the logarchive or a list of file names to copy. For logarchive, only 1 file
name is accepted to name the tar-archive that will be used to backup of the entire /var/
log directory. The archive is created in /tmp directory and will be automatically deleted.
This parameter is mandatory.
Synopsis: { true, false }
Default: false
If enabled, a time stamp will be appended to the file name. This option is not applicable
to file names that contain '*'.
Synopsis: A string 1 to 1024 characters long
The URL of the ROX II file to copy. Supported URIs are HTTP, SCP, SFTP, FTPS and FTP.
To save to a USB flash drive or microSD card (if applicable), the URL format is "usb://{usb-
device-name}/path-to-file" or "sd://sd-1//path-to-file". Run "show chassis" to determine the
name of the USB device. Note that only one single partition is supported for either data
medium.
Description
Device".
Description
RUGGEDCOM ROX II
CLI User Guide
Backing Up Files